Seal-All 380112 2 Oz All Purpose Contact Adhesive & Sealant for Strong Bonds

SEAL-ALL is the all-purpose adhesive used by hobbyists and mechanics alike to seal, bond, insulate, waterproof and stick to a wide variety of materials. Use it on practically anything: wood, steel, aluminum and copper; most plastics and rubber; porcelain, glass and china; vinyl, fiberglass, canvas and leather; cardboar

SEAL-ALL is the all-purpose adhesive used by hobbyists and mechanics alike to seal, bond, insulate, waterproof and stick to a wide variety of materials. Use it on practically anything: wood, steel, aluminum and copper; most plastics and rubber; porcelain, glass and china; vinyl, fiberglass, canvas and leather; cardboard, paper and much more! Fast-drying and clear, SEAL-ALL can withstand changes in climate, insulating and toughening with age. Known as “the repair kit in a tube,” it does not require mixing or heating, does not become brittle in cold weather and resists water, gasoline, oil and most solvents.

• Size: 2 Oz
• Fast dry time – set in 2-3 minutes
• E-Z flow formula
• Gas & oil resistant
• Waterproof – bond remains secure even when exposed to water
• Abrasion resistant
• Temperature resistant – remains tough even in extreme temperatures
• Tube
• Carded.

Instructions for Safe Use:

• Follow these step-by-step directions when using Seal-All:
• To open, puncture seal with pointer cap. Hold tube upright until ready to use. Do not squeeze tube to force opening. Replace cap after each use
• USE AS A SEALANT: Apply directly to clean, dry surface. Hold firmly until product sets. Additional coats may be applied. Allow each layer to dry thoroughly. On leaking objects under pressure, tape over Seal-Al® with Duct® or masking tape. Additional coats may be applied over tape
• USE AS A CONTACT ADHESIVE: Spread coating on each surface to be joined together. Allow to harden for 5-10 minutes, then press both surfaces together. Seal-All hardens by solvent evaporation and forms an immediate bond that is difficult to reposition after both adhesive coated surfaces are placed in contact and sufficient pressure is exerted to create full contact between both surfaces
• Seal-All will set in about 2-3 minutes and reaches full cure in 2-6 hours. Cure time increases with lower temperatures and decreases with higher temperatures
• Paint over Seal-All for UV resistance
• Keep threads at the neck of the tube free of Seal-All residue
• Store unused Seal-All at room temperature with cap tightened.

FAQs:

What is the most unique feature of Seal-All?

• Seal-All is resistant to gasoline, oil, paint thinner, and most solvents. Seal-All is also water resistant immediately upon applications

What substrates will Seal-All bond to?

• Seal-All adheres with superior strength to all substrates and materials except paper, cardboard and Styrofoam™. Always test a small area before full use

How long does it take for Seal-All to dry?

• Seal-All will set in 2-3 minutes and reaches full-cure in 2-6 hours. (Note: temperature and humidity will affect dry time.)

Is Seal-All UV resistant?

• No. Seal-All may be painted over for maximum UV resistance once cured

What are some suggested uses for Seal-All?

• Use for distributor caps, interior panels, radiators, gaskets, transmission carburetor floats, body and trunk leaks, battery cables and terminals, generators, tools and much more.

WARNING: This product can expose you to chemicals including acetaldehyde which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.

Specifications

MFR: 380112 SKU: 11327497 UPC: 076818801122 Brand: Seal-All Length: 7 Width: 7 Height: 7