Roof Saver RS20G Rolled Ridge Vent Flexible

Roof Saver Rolled Ridge Vent is cost-effective attic ventilation that provides a cosmetically superior appearance compared to unsightly fans or vents. 100% natural fiber is bristly which helps to grip the roof making installation easier. 3 dimensional black matting manufactured from natural fibers which are laid on a p

Roof Saver Rolled Ridge Vent is cost-effective attic ventilation that provides a cosmetically superior appearance compared to unsightly fans or vents. 100% natural fiber is bristly which helps to grip the roof making installation easier. 3 dimensional black matting manufactured from natural fibers which are laid on a polyester mat.

• 100% natural fiber is bristly which helps to grip the roof making installation easier
• Meets or exceeds attic ventilation requirements of all nationally recognized building codes
• Eliminates unsightly fans and vents
• Flexible
• Protects roof and shingles from damage due to excessive heat or condensation
• Passes 110 mph independent wind driven rain tests
• Most economic and efficient way to ventilate your attic with 15.2 square inches of net free ventilation area per linear foot
• Provides uniform ventilation
• Class A fire rating
• Won’t deteriorate or corrode from wind, snow, rain or ice
• Single rolls are boxed
• 1 coil of roofing nails & 2 nail gun pads are included for installation
• Ice evaluation report ESR-1218 & passes miami dade county building codes
• Provides a cosmetically pleasing finish to a home
• Dimension: 3/4″ (D) x 10.5″ (W) x 20′ (L).

Installation instructions:

• Remove ridge cap shingles along entire length of roof
• Measure 1″ from ridge peak on each side of ridge. For ridge board construction measure 1-3/4″ on each side of ridge
  Snap chalk line along entire length of ridge
  Cut opening in sheathing along ridge. DO NOT CUT through roof trusses or ridge board
  Remove sheathing to create slot
  Leave a minimum of 12″ of sheathing closed at each end of ridge
• Tack one end of Roof Saver® ridge vent, with netting side down, over the slot to hold in place at one end of the ridge. Unroll entire length of vent, pull to remove sags and tack in place so vent is snug and centered over slot. If more than one piece of Roof Saver® is needed, simply butt the multiple pieces together and tack in place with a nail
• Install ridge cap shingles directly over Roof Saver®. Use galvanized roofing nails included in package to secure in place. When properly installed, Roof Saver® fills the 3/4″ space between the underside of the cap shingle and the top surface of the roof shingles. Do NOT drive nails through shingle.

Specifications

MFR: RS20G SKU: 11581319 UPC: 076785000016 Brand: Roof Saver Length: 17 Width: 17 Height: 13